5 Tips for Making Your Water Heater More Energy Efficient

Over time, many appliances fail to work as efficiently as they did when they were brand new. Your water heater is no exception. Often time can cause your water heater to allow your home to waste energy as well as your money on your energy bill each month. Luckily, there are various options that you can employ to make sure you conserve energy as well as possible by making adjustments to make your water heater more efficient.

  1. Often older heaters lose a great deal of their insulation. Just like the walls of your home, insulation keeps temperatures in. When insulating deteriorates, it allows energy and heat to escape without heating your water properly. This causes your water heater to work harder and use more energy to heat the water you are using. One way to enhance the insulation of your water heater is to purchase an insulation blanket. Insulation blankets are usually inexpensive and you can install it yourself. Insulation blankets easily wrap around the outside of your water heater’s tank. Be aware that your do not cover up any important features of your tank such as the thermostat or other gages. These need to remain exposed and accessible.
  2. You can also insulate the pipes that lead to and from your water heater. To do this, you will need to purchase pipe sleeves. These fit easily over the pipes. Installation should not be a difficult process but can become problematic if you pipes are located in tight or hard to reach spaces.
  3. Turn the thermostat temperature down on your water heater. Often water heater thermostats are set too high, using more energy than necessary to heat your water. As a rule of thumb, always be sure your thermostat is set to approximately 120 degrees Fahrenheit. This will help your heater work more efficiently. To be sure the heat is set to 120, however, you should not always rely on your thermostat because these may not be calibrated properly over time. Use a separate thermometer stick to check the temperature before you change the thermostat temperature. Once you change the temperature, come back after about 20 minutes and measure the temperature with your thermometer again to be sure of the temperature.
  4. Another option is to drain your water heater. It is recommended that you drain your heater at least one of two times a year. It used to be recommended that you completely drain them each time. Now, this advisory has changed. You should instead drain your tank much more frequently (an estimate of once every 3 to 4 months) but you do not need to drain the entire tank. You should only drain about a quarter of the tank at a time. This will take you less time to complete and so it is feasible that you can drain the tank more regularly instead of making the event a much larger project. Draining your tank can be done with a garden hose that is attached to the bottom and allows water to flow out into your floor drain.
  5. Finally, you can also help your water heater to be more efficient by trying to reduce hot water use in your home. This can start with reducing the use of hot water using appliances such as your dishwasher or washing machine. For the dishwasher, try using the economy setting, which performs a pre-wash. Instead, rinse and clear dishes before putting them in the dishwasher to use les hot water. In the case of your washing machine, try to use the cool or cold water settings whenever possible to limit your hot water use and be more energy efficient. You can also make change din your shower. Most showerheads waste a great deal of water. You can instead choose to install an inexpensive alternative with a flow that is much lower. The water pressure may be reduced and so you will not use as much hot water in one shower.

Each of these options will help your water heater to become more efficient so that you can save energy. Wasting energy harms the environment and costs you extra cash out of your pocket, however it can absolutely be prevented and reduced. Be sure to reduce hot water usage in your home, drain your tank regularly, set the heater thermostat to about 120 degrees Fahrenheit, and insulate the tank and pipes to best save energy used by your water heater.

photo by:

brianc

Leave a comment

0.0/5